Description
The H2O Kit #3 BULK Repair Kit contains everything you need to begin using our H2O Aquabonder Glue for PVC pipe repair and stuctural application use under or above water. Equipped inside a stylish carrying case each kit contains the correct Pak-50 dispense gun along with (4) 50 ml cartridges of our H2O Aquabonder Underwater Adhesive with (10) Extra Mixing Nozzles, (1) 2″x10ft and (1) 4″x10ft Fiberglass Cloth Roll for Pipe Repair as well as (2) 6″ Spreaders and (2) Mixing Boards.
Each Kit Contains:
- (1) Carrying Case
- (4) tubes of H2o Aquabonder Adhesive 50 mL
- (1) Pak-50 Dispense Gun
- (10) Extra Mixing Nozzles
- (1) 2″x10 ft Fiberglass Cloth Roll
- (1) 4″x10 ft Fiberglass Cloth Roll
- (2) Mixing Boards
- (2) 6″ Beveled Edge Spreaders
H2O Underwater Glue is a toughened structural adhesive used to bond to ABC Plastic, Fiberglass and PVC. The H2O Glue is perfect for repairing pipes, skimmers and main drains.
Bonds To: PVC, Fiberglass, ABS, FRT, PBT, PPO, PCBB, Metton®, Lomod®, Valox®, Noryl®, GTX, Minlon®, epoxy, RIM urethane,wood, poorly prepared surfaces, and where outdoor weathering or solvent exposure is anticipated
Product Features:
- Minimal surface preparation
- Room temperature cure
- 1:1mix ratio
- Rapid fixture in thin set
- Non-sagging formula
- Apply mixed product directly to one surface in an even film or as a bead.
- Assemble with mating part within recommended working time.
- Apply firm pressure between mating parts to minimize any gap and ensure good contact, (a small fillet of product should flow out the edges to display adequate gap.)
- Bond line thickness of mixed adhesive should be @ .015″-.030″ for optimum adhesion
| Color | Off-White/Straw |
| Working Time | 4-6 min. @ 72°F, 22°C |
| Fixture Time | 10-15 min.@72°F, 22°C |
| Functional Cure | 45-60 min.@72°F, 22°C |
| Full Cure | 24 hours |
| Flashpoint | 51°F |
| Mix Ratio by Weight/Volume | 1:1 |
| Mixed Density | 8.20lbs./gal. / .98gm/cc |
| Mixed Viscosity | 50,000 cps |
| AdhesiveTensile Lap Shear[ABS] | 1,300 psi |
| AdhesiveTensile Lap Shear[GBS] | 3,500 psi |
| AdhesiveTensile Lap Shear[Polycarb] | 1,400 psi |
| Gap Fill | 0.125 in. |
| Impact Resistance | 22 ft.lb./in^2 |
| Service Temperature | -67°F to 250°F |
| Shore Hardness | 78 Shore D |
| Solids by Volume | 100 |
| Specific Volume | 28.1 in^3/lb |
| Tensile Elongation % | 15-25% |
| Tpeel | 35-40 psi |
Reviews
There are no reviews yet.